cement kiln dust collector

The cement kiln dust collector is a cylindrical glass fiber bag dust collector, which mainly provides a good environment for filter bag screening, inertia, diffusion, adhesion, and static electricity to achieve efficient and energy-saving dust removal effect. It also uses the inlet and outlet pressure difference control back blowing system device to filter and operate between 800pa-1500pa, providing protection and completely solving the common problems of condensation, bag burning, corrosion, and secondary dust caused by bag sticking.

Product Features

1. The export emission concentration is much lower than the prescribed 100mg/Nm3 emission standard.

2. The structural design is fully demonstrated, and the operation is convenient, reliable, economical, and practical.

3. Small footprint, easy installation and maintenance, compared to the above three points, it is your ideal choice.

Technical requirements:

The main concrete frame is designed with personnel according to specific models.

The installation and maintenance platform for stairs shall be determined by both parties through specific on-site discussions on the structural form.

The lower ash removal and conveying method shall be provided by the purchaser in the form of preparation.

Installation and commissioning precautions:

Strictly control leakage at all cavity connections between imports and exports to prevent a significant decrease in dust removal efficiency.

Before installing the filter bag, carefully check for any signs of damage during operation, and it is strictly prohibited to use unqualified bags.

All transmission and opening moving parts must ensure that they are within the specified degrees of freedom.

The installation of the main body shall be strictly checked for errors according to regulations to ensure compliance with requirements.

After installation, carefully inspect all chambers for the presence of foreign objects and clean them thoroughly? After the above inspection is confirmed to be correct, the main fan and other control devices can be started again. The main fan and other control devices should be observed to see if all displays are normal. Once any abnormalities are found, the machine can be stopped and eliminated before restarting.